A2 · Victoria, BC
Assembly — food, worship and community in Victoria: what the code requires
What binds an assembly, restaurants and halls (a2) building in Victoria?
In Victoria, the binding constraint on a assembly — food, worship and community building is egress: occupant load sets the number of exits and their width before any system is specified, under the British Columbia Building Code 2024 (BC Reg. 216/2023).
Systems required
7
typical 2-storey, 20k sf profile
Full-retrofit capex
$210,224–$736,400
if nothing is in place
Occupant load basis
A2
class
Code in force
BC
British Columbia Building Code 2024 (BC Reg. 216/2023)
Run your building, not the typical one
Pre-filled for an assembly, restaurants and halls (a2) building in Victoria. Change the storeys, area and systems in place to get your own gap list and memo.
Set the occupancy, size and systems on the left. The generator returns the required systems with code citations, the gap list with capex bands, and a printable scope memo.
What inspectors fail assembly, restaurants and halls (a2) buildings on
- Occupant loads running above the posted limit at peak service
- Tables and chairs narrowing aisles below egress width
- Exit signs hidden behind décor
- Annual alarm verification skipped after ownership changes
- Kitchen suppression systems overdue for semi-annual service
Restaurants, places of worship, community halls and other gathering spaces without fixed theatrical seating. High loads and occupant unfamiliarity make egress the binding constraint. In Victoria, these buildings are read against the British Columbia Building Code 2024 (BC Reg. 216/2023), in force since 2024-03-08, with maintenance enforced under the British Columbia Fire Code 2024.
The occupant load is the number everything else hangs on. NBC 2020 Div. B Table 3.1.17.1 — space with nonfixed seats and tables, 0.95 m² per person (standing space 0.40 m²). Once the load is known, the code sets the exit count, the egress width, and whether the alarm and sprinkler triggers fire. An owner who guesses the load guesses the whole scope.
What inspectors actually fail assembly, restaurants and halls (a2) buildings on in British Columbia is consistent: occupant loads running above the posted limit at peak service; tables and chairs narrowing aisles below egress width; exit signs hidden behind décor. The pattern matters because most of it is maintenance discipline, not capital — but the items that are capital, like suppression matched to the wrong hazard, are the expensive surprises.
Budgeting should use region-adjusted bands. Securlor models British Columbia at 112% of the national baseline; a sprinkler retrofit that prices at $8 per square foot nationally models near $8 here. Sequence the scope: life-safety gaps that block occupancy or insurance first, monitoring contracts second, elective hardening last.
This page is a planning scope. The authority having jurisdiction in Victoria — not this site — decides what binds a specific building, and a qualified professional must confirm the requirement set against the adopted edition.
Planning scope — This is a planning scope, not a code compliance opinion. Code interpretation is jurisdictional and enforced by the authority having jurisdiction — a municipal official, not this site. Confirm every requirement against the adopted code edition with a qualified professional before you design, budget or build.
How these figures were produced
- Observed — Recorded directly from the cited source series, unadjusted.
- Modelled — Derived arithmetically from observed inputs using the published method; not a market quote.
Sources
- [1] British Columbia Building Code 2024 (BC Reg. 216/2023) — requirement framework for British Columbia
- [2] British Columbia Fire Code 2024 — maintenance and inspection duties
- [3] Securlor modelled cost series — national baseline, region-adjusted
What life-safety systems does a Assembly, restaurants and halls (A2) building need in Victoria?
Run the scope generator above with your storeys, floor area and existing systems — it returns the required list with the code clause for each. The requirement set depends on occupant load and building height, not just the occupancy class.
How is occupant load calculated for a Assembly, restaurants and halls (A2) building?
NBC 2020 Div. B Table 3.1.17.1 — space with nonfixed seats and tables, 0.95 m² per person (standing space 0.40 m²).
Which code edition applies in Victoria?
The British Columbia Building Code 2024 (BC Reg. 216/2023), with maintenance under the British Columbia Fire Code 2024. In force since 2024-03-08.
Is this a code compliance opinion?
No. It is a planning scope assembled from the published model code. The authority having jurisdiction governs, and a code consultant or fire protection engineer must confirm the scope before you act on it.
The scope above wrote its compliance capex into your deal file. Carry it to a sister site to price the rest of the transaction, or read the Victoria market page for the full code picture.
Not advice — Securlor is a data publisher. Nothing here is professional, financial, legal, or investment advice, and nothing here is an offer or a quote. Figures are indicative benchmarks for comparison and must be confirmed with a qualified professional before you rely on them. About Securlor